Tag: lighting

Retro Tech

Timothy Price7 Comments

DSCF9092

In our reorganization, Laurie pulled out a lot of old equipment. This 4th Generation iPod and DLO iBoom are a couple of the gems we’ve had around for awhile because they are now obsolete for our purposes because we have newer computers and iPhones. While the Gen 4 iPod and iBoom are only 10 years old, they might as well be 100. The iPod/iBoom combination produces fine, loud audio, and has a nice retro tech look, but while Gen 5 and newer iPods and iPhones up to the iPhone 5 will plug into the dock on the iBoom, they will not play. I suspect they don’t have enough power to drive the system. The Gen 4 iPod is thick, clunky and power hungry compared to the thin, more elegant iPod touches and iPhones. So these classic pieces are now a retro tech couple, united until death does them part.

Catio Concrete

Timothy Price11 Comments

45CU2424

It’s not really concrete, but a cement top coat used for refinishing concrete surfaces. The refinishing cement is really intended for fairly smooth slabs, but the slab in the catio is very rough concrete, so getting a really smooth top coat didn’t happen.

A lone leaf decided it needed to break in the new cement floor, since I have the cats locked out of the catio while the cement cures. In the second photo, there are three dominant shades of gray. I mixed the first batch of cement following the instructions exactly, and the mixture ended up being too thick, so while it poured out of the bucket, it started setting up almost immediately, making it difficult to spread, and almost impossible to smooth as per the instructions (it’s the darkest shade of gray along the back wall).

I made the second batch soupier than the first, but I got it a little too soupy, so it spread thinner than I wanted it to (lighter shade of gray in the middle). On the third batch I got the mixture figured out so it spread well at the thickness I needed, and I was able to get it a little smoother (middle shade of gray in the foreground). I used the same mixture for the the next 8 batches needed to cover the entire slab. I also ended up spreading and smoothing the cement on my hands and knees with a hand trowel. Our air is so dry here, that even the wetter mixtures started setting up as soon as I poured them out of the bucket, making it difficult to spread with the 18 inch-wide cement spreader the instructions suggested I use.

While I was photographing the new floor, I noticed my little chainsaw and level on a bonsai shelf made a nice composition. The last two photos are the candles we have behind the couch in the sunroom unlit and lit.

45CU2427

 

45CU2429

 

45CU2428

 

45CU2432

 

 

Fashion Laur & Puzzle Cats

Timothy Price9 Comments

DSCF9134

Since the dance room/photo studio is still full of stuff from our reorganizing, I had to get a shot of Laurie in her cute outfit of the day as she was literally ready to step out the door. The cats were all stacked up like a puzzle on me when I woke up, and the house was so cold that after some effort to extract myself, the cats stayed in place locked together. Even Mama Manx, who is always spring loaded, and normally jumps off the bed from my slightest movement, held firm on the edge of the bed waiting for the heat to come on.

DSCF9127

 

Wet Spot

Timothy Price7 Comments

DSCF9077

There was a wet spot on the carpet in the office this morning, but no signs of a leak in the ceiling. As the wet spot spread, we finally pulled up the carpet to find a combination of plaster, spackling, and 1/4 in masonite on the slab. I started pulling up the wet masonite and chipping up the moist spackling and discovered a 2 inch piece of pine that had been cut into a circle to cover a drain in the floor. We were speculating a sewer line froze and water backed up through the old drain, but then we noticed that while the top of the pine was soaking wet, the underside of the pine was dry, which suggested that the water did not come up through the old drain. I continued to chip back the plaster and spackling until I found dry edges all around the wet spot. The source of the water remains a mystery among puzzling evidence, but we’ll see if we have standing water on the chipped up floor in the morning.

DSCF9080

 

DSCF9082

RX-8 on Ice

Timothy Price9 Comments

DSCF9071

We had a light snow most of the day, which left a dusting of snow on top of a hardened layer of thin ice that was not much fun to scrape off the windshield and windows. After 40 minutes on the road, I stopped at the post office in Corrales to pick up the mail, and noticed that the ice and snow stuck on the hood was only a little wind-streaked.

DSCF9072

DSCF9076

Cat Help in the Catio

Timothy Price16 Comments

45CU2365

Work continues on the catio. We started preparing the old cement slab for resurfacing on Saturday, but then we discovered we needed to rent a high pressure sprayer to clean it before we put on the resurfacing cement, plus the temperatures are supposed to stay above 50º F for 8 hours after the new surface is applied. Since the temperature only got into the 40’s over the weekend we decided to prepare surfaces for painting.

The first photo is Laurie preparing to wire brush the French windows so I could paint them. In the second photo, she is telling Rosencrantz and Guildenstern what they could do to help. The third photo shows Guildenstern supervising Laurie. He had a lot to say about our work, so much so, that it wore him out and he had to take a break (fourth photo). The French windows and door had not been painted in 22 years. The ivy had grown up on them which marked and pulled off paint in various places, so I spent a good part of the day painting the windows and doors with a very good, “stain killer” primer. The last photo shows Laurie standing by the freshly primed windows.

As I have mentioned before, we live in a cold spot — the reason Laurie was dressed in layers of warm clothes to work on the catio. We went to a dinner party last night in Albuquerque. When we left the party at a little after 10:00 PM, the car showed the outside temperature was 47º F. When we got home 20 minutes later, the temperature at our house was 26º F. We live about 10 miles north and west as the crow flies, and about 700 feet lower than the part of Albuquerque we attended the dinner party, yet we were 21degrees colder.

45CU2376

 

45CU2378

 

45CU2381

 

45CU2391

Let a Sleeping Cat Lie?

Timothy Price22 Comments

IMG_0558

Rosencrantz was so cute sleeping in, that I had to do a photo. I got only one shot of him sleeping before he kitty-sensed my camera, woke up, and looked around a bit disoriented. He was definitely unhappy with me disturbing his bliss by taking a photo of him while he was sleeping.

IMG_0559

 

IMG_0561

Waiting on a Waffle/Breakfast with Guildenstern

Timothy Price2 Comments

A18W0573

I had to get out my 17mm, super-wideangle lens to get a photo of Beaker impatiently waiting for the waffle that’s in the toaster oven. You can see the tips of his wings are a little blurry because he is fluttering them in anticipation. Guildenstern got up on the table, flopped himself down and waited to see what Laurie was having for breakfast. He wasn’t too sure about either the granola or the coffee.

A18W0577

DSCF9016